User`s manual

DIGITAL-LOGIC AG MSMP5 / P3 SEN/SEV Manual V1.6A
29
4 D ETAILED S YSTEM D ESCRIPTION
This system has a system configuration based on the ISA architecture. Check the I/O and the Memory map
in this chapter.
4.1 Power Requirements
The power is connected through the PC/104 power connector; or the separate power connector on the
board. The supply uses only the +5 Volts and ground connection.
Warning: Make sure that the power plug is wired correctly before supplying power to the
board ! A built-in diode protects the board against reverse polarity.
Tolerance of 5V supply: 5 volts ± 5%; Power-fail signal starts at ± 10 % of 5 volt norm and generates a
reset status for the MICROSPACE PC.
Testenvironment for powerconsumption measurement:
Peripheries:
Harddisk Hitachi Mod-DK23AA-60 DLAG: 890005
Monitor Compaq Mod-460
PS/2-KB Logitech Mod-iTouch Keyboard
PS/2-MS Logitech Mod-M-CAA43
Floppy TEAC Mod-FD-05HF
Software:
MS-DOS V6.22
Win2000, WinME
HCT for Win2000 v9.5 BM v1.033d