User`s manual

DIGITAL-LOGIC AG MSMP5 / P3 SEN/SEV Manual V1.6A
117
10.2.6 EEPROM update
Do not use this function, if the EEPROM is not corrupted !
To download the datas in the EEPROM, make the following steps:
- copy the folder << x:\drivers\network\intel\82559er\eeupdate >> to a floppy disk.
- start MSDOS
- type the following string:
a:\eeupdate -all -device=1209 generic.eep generic.dat
Now the EEPROM is updated again.
10.3 Compact Flash (CF)
Procedure to prepare a CF to be bootable:
DOS:
1. Check, if CF gets recognized in the BIOS setup
2. Use FDISK to erase partition
3. Use FDISK to create a new partition
4. Use FORMAT to format the CF
5. Use SYS to copy the system files onto the CF
• You might set the parameters manually (CYL/SEC/HEAD/LBA/etc)
• Not every CF on the market might get recognized. They might behave differently in starting time.
10.4 IrDA
Since BIOS version V2.36, standard- IrDA can be accessed through the connector X46.
10.4.1 BIOS Settings
I/O Device Configuration :
Serial Port B : Auto oder Enabled
Mode : IRDA
Base I/O Adress : 2F8
Interrupt : IRQ 3
10.4.2 Installation Windows 2000
• When booting Windows, an „internal infrared device“ will be detected and installed
• Go to the device manager and delete this device. Do not re-boot but add a new device:
Infrared device
Hewlett Packard
HP- infrared communication
• Reboot Windows 2000