User`s manual

DIGITAL-LOGIC AG MSMP5 / P3 SEN/SEV Manual V1.6A
112
8.5 Remote function
Use a Null- modem cable to connect COM1 of the DLAG- board to COM1 (COM2) port of the host- PC.
These are the minimum requirements:
PC1 DSub 1 connector DSub 2 connector PC2
Receive Data 2 3 Transmit Data
Transmit Data 3 2 Receive Data
Data Terminal Ready 4 6 Data Set Ready
System Ground 5 5 System Ground
Request to Send 7 8 Clear to Send
When the option REMOTE is enabled in the BIOS, start the program HOSTKEY.EXE on the host- PC. After
that, start the DLAG board and one will see the context on the host – PC.
Usage: HOSTKEY [ /? | /Cx | /Sxx | /NOF | /V ]
where /? = this screen
/C1 = COM1 (DEFAULT)
/C2 = COM2
/S96 = 9600 baud
/S192 = 19200 baud
/S384 = 38400 baud
/S576 = 57600 baud
/S1152 = 115200 baud (DEFAULT)
/NOF = do not check for floopy disk when loading HOSTKEY
/V = verbose mode, display HOSTKEY messages
Example:
HOSTKEY /C1 /S384 /V
Control-X to exit. CTRL-ALT-F10 to reboot target.
NOTE:
- Chipset BX has no USB support while in REMOTE mode
- Chipset TX has USB support while in REMOTE mode