User`s manual

DIGITAL-LOGIC AG MSMP5 / P3 SEN/SEV Manual V1.6A
108
8 C ABLE INTERFACE
8.1 The harddisk cable 44pin
IDT Terminal for Dual Row (2.00 mm grid) and 1.00 mm flat cable. 44 pins = 40 pins signal and 4 pins
power.
1 1 2
4343 44 44
39 39 40 40
2
Max. length for the IDE cable is 30 cm.
ATTENTION:
Check the pin 1 marker of the cable and the connector before you power on. Refer to the technical manual of
the used drives, because a wrong cable will immediately destroy the drive and/or the MICROSPACE
MSMP5SEN/SEV board. There is no warranty in this case! Without the technical manual you may not con-
nect this type of drive.
The 44pin IDE connector on the drives are normally composed of the 44 pins and 2 open pins and 4 test
pins, 50 pins in total. Leave the 4 test pins unconnected .
1 3 43a b
c d
Testpin
open pin
44pin IDE Interface with integrated power lines