User`s manual

DIGITAL-LOGIC AG MSMP5 / P3 SEN/SEV Manual V1.6A
100
6 J UMPER LOCATIONS ON THE BOARD
Jumper locations on the board
The figure shows the location of all jumper blocks on the MSMP5SEN/SEV board. The numbers shown in
this figure are silk screened on the board so that the pins can easily be located. This chapter refers to the
individual pin for these jumpers. The default jumper settings are indicated with asterisks. Be careful when
you change some jumpers.
Some jumpers are soldering bridges, you need a miniature soldering station with vacuum pump.
The Jumpers
Jumper Texture 1-2 = open 2-3 = closed
Rem
J28 Supply PCI bus
Buffers are not switched, only signal
(J18 pin B6)
1-2 = +5V
2-3 = +3.3V
J30 RTC reset open = reset
closed = running
J44 Watchdog
1-2 = enabled
2-3 = disabled
J45 LCD supply
1-2 = +5V
2-3 = +3.3V
J47 CPU select 1-2 = P3 2-3 = P5
V3.7x
J48 Mainswitch manually set
1-2 = OFF
2-3 = ON
V3.7x
J49 Mainswitch controlled by
1-2 = CPU (SUSC)
2-3 = J48
V3.7x
Settings written in bold are defaults!