User`s guide

5-18 DL600E E1 Data Multiplexer UserÕs Guide
2 To select a network timeslot:
Ñ Go to
TS CONFIG NET by pressing the Up or Down Arrow.
You can now select a network timeslot and allocate it.
Ñ Press
ENTER to display the slot 1 status.
Ñ Press
Up Arrow to open the display for network timeslot 2.
Ñ Press the
Up Arrow to move to IDLE and press ENTER then
ENTER again to conÞrm the change.
Ñ For timeslot 5, press
ENTER to open the display and ENTER
again to activate edit mode for the port.
Ñ Press Up Arrow and ENTER to move to and select data port 2.
3 Use this method to manually allocate each network timeslot to
a data port.
ConÞguring for SNMP
To conÞgure the DL600E unit for SNMP from the front panel, use the
SNMP CONFIG menu.
For a description of the SNMP parameters refer to ÒConÞguring for
SNMPÓ in Chapter 3.
The parameters in the
SNMP CONFIG menu are
TS CONFIG NET
NET TS01 DATA01
NET TS02 DATA01
SNMP CONFIG
ENTER
RST CMMUNTY STR
IP 0.0.0.0
MSK,0.0.0.0
1ST NMS,0.0.0.0
SNMP ENABLE NO
SNMP PORT COMM