User`s guide

Using the Front Panel Interface 5-17
The timeslot allocation for port 1 appears:
4 To allocate slots to port 2:
Ñ Move to port 2 by pressing the
Up Arrow:
Ñ Press
ENTER to activate edit mode.
Ñ Press the
Up Arrow (the start timeslot, 01, starts to blink).
Ñ Press the
Up Arrow to move to slot 16 and press ENTER to
select it and move to the end timeslot.
Ñ Press the Up Arrow to reach 31 and press ENTER.
Ñ Press
ENTER to conÞrm your change when prompted:
TO CHANGE CONFIG
YES--ENTER, NO--EXIT
Ñ The timeslot allocation for port 2 appears:
Allocating Timeslots Manually in a Random Order Example
To allocate timeslots in a random order:
Timeslots 1, 4, and 8Ñdata port 1
Timeslots 5, 7, and 9Ñdata port 2
use the following example.
You are in default mode:
1 From TIMESLOT CONFIG, press ENTER, then ENTER again to
activate edit mode.
TS CONF CONTIG appears with CONTIG blinking.
Use the
Down Arrow to move to TS CONF MANUAL and press
ENTER, then ENTER again to conÞrm the change.
DTE01 TS = 01 -- 15
DTE02 IDLE
DTE02 TS=16 -- 31
DTE01 TS = 01 -- 31
TS CONF CONTIG
TS CONF MANUAL