User`s guide

5-16 DL600E E1 Data Multiplexer UserÕs Guide
Changing the Allocation for Occupied Slots
When you try to allocate an occupied slot to another port from the front
panel interface, an error message appears. You must Þrst make a slot
idle
to allocate it to another port. (This restriction is present only on the front
panel interface.)
Allocating Timeslots Contiguously Example
This example shows how to allocate timeslots 16 through 31 to data
port 2. You are in default modeÑall slots allocated to port 1. You will
change the slot allocation for port 1 to 1 through 15 to free the last 16
slots and allocate the slots to port 2.
To allocate timeslots in a contiguous order:
1 Open the TIMESLOT CONFIG menu by pressing ENTER.
The TS CONFCONTIG submenu appears.
2 Press the Up Arrow to move to data port 1.
3 To reallocate slots 1 through 15 to port 1:
Ñ Press
ENTER to activate edit mode.
The start timeslot 01, start to blink.
Ñ Press
ENTER to move to the end timeslot which starts to
blink.
Ñ Press the Down Arrow repeatedly until you reach 15 and press
ENTER
to select it.
Ñ Press
ENTER to conÞrm your change when prompted:
TO CHANGE CONFIG
YES--ENTER, NO--EXIT
TS CONF CONTIG
TIMESLOT CONFIG
ENTER
TS CONF CONTIG
DTE01 TS = 01 -- 31
Default timeslot allocation
DTE01 TS = 01 - - 24