User`s guide

5-6 DL600E E1 Data Multiplexer UserÕs Guide
Editing a Parameter
To modify a parameter such as the unit ID:
1 Press ENTER to open the CONFIGURATION MENU.
The
UNIT CONFIG submenu appears.
2 Press ENTER to open this menu and ENTER again to activate
edit mode (the Þrst
ID character starts to blink).
3 Edit the ID one character at a time.
When the character is blinking, use the
Up or Down Arrow key to
cycle to the desired character and press
ENTER to select the
character.
If you do not wish to edit a character, press ENTER to move to
the next character position.
4 Press ENTER to conÞrm changes when the system prompts:
TO CHANGE CONFIG
YES--ENTER, NO--EXIT
or press EXIT to exit without executing the change.
UNIT CONFIG
ENTER
UNIT ID HARRY
ENTER
UNIT ID
HARRY
First character
starts to blink