User`s guide

Monitoring and Managing the DL600E Unit 4-7
Menu-1 Main Status Parameters
All parameters in Menu-1 are read-only.
Unit Status
Unit Status indicates if the DL600E unit is operating normally or
if any special conditions exits. When the DL600E unit is
executing a test, the test is indicated in this Þeld. (If the test is
running on a port, the port appears in parenthesis.
Indication Description
Normal No abnormal conditions exist
Self Test Unit is running self test.
DTE Loopback (fraction) Unit is in DTE loopback
AUX E1 Loopback
(fractional)
NET Loopback (full) Unit is in network loopback.
PLD Loopback (fraction) Unit is in payload loopback.
Send User 1
(fraction) Unit is sending User 1 pattern.
Send User 2
(fraction) Unit is sending User 2 pattern.
Send
1:1 (fraction) Unit is sending alternate 1s and 0s pattern.
Send
1:2 (fraction) Unit is sending standard loop down remote code
continuously.
Send
1:4 (fraction) Unit is sending standard loop up remote code
continuously.
Send
1:7 (fraction) Unit is sending 1:7 pattern.
Send
3:24 (fraction) Unit is sending 3:24 pattern.
Send
QRW (fraction) Unit is sending QRW code.
Send All 1s
(fraction) Unit is sending all ones signal.
Send All 0s
(fraction) Unit is sending all zeros signal.
LP UP Remote (fraction) Unit is sending loopdown code to remote unit for
15 seconds.
LP DN Remote (fraction) Unit is sending loopup code to remote unit for 15
seconds.
Send RAI Unit is sending RAI (Remote Alarm Indication).
No Clock Clock source has failed.
Lamp Test Unit
is undergoing Lamp Test.