User`s guide

ConÞguring the DL600E Unit 3-29
External Alarm Input MessageÑ(20 characters maximum)
Appears in the menu only when the remote unit is a DL600E unit
and applies only to it.
Enter an alarm message
(20 maximum) that will appear when an
external alarm occurs. E
xternal Alarm Input Indication must be
enabled and
External Alarm Input Contacts must be properly set.
External Alarm Output IndicationÑEnabled, Disabled
(DefaultÑDisabled)
Appears in the menu only when the remote unit is a DL600E unit
and applies only to it.
Select
Enabled to enable a device, connected to the ALARM OUT
connector (such as a bell or light)
External Alarm Output ContactsÑ(DefaultÑNormally Open)
Appears in the menu only when the remote unit is a DL600E unit
and applies only to it.
(View only)
Normally Open ÑAlways.
ConnectionÑIn-Band Communications, Modem, Direct
(DefaultÑDirect)
Select the connection you are using.
In-Band CommunicationsÑEnables a remote unit connectrion.
ModemÑEnables a modem connection to the DL600E unit.
DirectÑEnables a direct terminal connection to the DL600E
unit.
Timeout When Logged OnÑ1 Min, 15 Min. 30 Min., Unlimited
(DefaultÑUnlimited)
Applies only when you are logged on. This is the time span after
which, if it does not detect activity, the system warns you will be
logged off in 30 seconds.
Timeout When Not Logged OnÑ1 Min, 15 Min. 60 Min., Unlimited
(DefaultÑUnlimited)
Applies only when a terminal is connected through a modem
and you are not logged on.This is the time span after which the
modem disconnects the phone line if no activity is detected.