User`s guide

ConÞguring the DL600E Unit 3-19
2 To specify Data Port 1:
Ñ Press the Down Arrow to move to Allocate by Port and
Return
to activate edit mode.
Ñ Press
01 (for Data Port 01) and Return.
D01 appears in Allocate by Port and the start timeslot
begins to blink. (You can specify only port
1.)
3 To specify the start timeslot and end timeslot:
Ñ Press
1 and Return to specify start timeslot 1.
DATA01 TS01 appears; end timeslot Þeld starts to blink.
Ñ Press
14 and Return and y for timeslot 14.
Ñ appears in the
Allocate by Port
Þeld and timeslots 1 through 14 are allocated to port 1; all other
slots are idle.
Ñ
Press y to conÞrm your action when prompted.
Refer to the example in Figure 3-4.
Allocating Timeslots Manually
To manually allocate timeslots to a speciÞc data port, move to the
timeslot and specify the port. You must set the other timeslots to
Idle.
Timeslots for the AUX E1 port can only be allocated manually.
Follow the procedure described in the example below.
Example: You want to allocate timeslots
3, 7, 9, 14, and 15 to data port 1.
Your plan is to specify port
1 for these timeslots and for IDLE for all
other timeslots.
1 To select Manual.
Ñ Move to
Allocation Type using the Up or Down Arrows
and press Return to activate edit mode.
Ñ Cycle through the options using the
Up or Down Arrows.
Ñ To select
Manual, press Return, then press y to conÞrm.
2 To conÞgure timeslot 1 as IDLE.
Ñ Move to timeslot
1 using the Down Arrows.
Ñ Press
Return to activate edit mode.
The system prompts:
Type the UP or DOWN arrows to change the selection, or
type a port number (NN or I for IDLE):
DATA01 TS01-TS14 896 Kb/s