User`s guide

3-18 DL600E E1 Data Multiplexer UserÕs Guide
SW Ver 1.0 MIB Ver 1.1 Digital Link DL600 Encore 04/22/95
HW Ver A Menu-6 Timeslot Configuration 12:56:56
Local: OAHU Remote: MAUI
Allocation Type Contiguous Contiguous
Allocate by Port:
D ATA 01 TS01-TS31 1536Kb/s DATA 01 TS01-TS18 1280Kb/s
Allocated by Timeslot:
Network Timeslot Map
1 2 3 4 5 6 7 8 9 10 11 12131415
Local D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01
D01RemoteD01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01
16 17 18 19 21 22 23 24 25 26 27 28 29 30 31
Local D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01 D01
Remote D01 D01 D01 D02 D02 D02 D02 D02 D02 D02 D02 D02 D02 D02 D02
0-SNMP Config 1-Main Status 2-Data DTE Status 3-Reports 4-Main Config.
5-Data Port Config. 6-Timeslot Config. 7-Alarm I 8-Alarm II 9-Diagnostics
Type Arrow keys to move the selection, RETURN to change a selection
or type 0 through 9 for a new menu:
Figure 3-4 Menu-6 Timeslot ConÞguration
In the example in Figure
3-4, timeslots 1 through 14 are allocated to
port 1 in a non-contiguous order. The remote unit as one of the
following: a DL600E, Solo E1 standalone unit (DL085E), a DL600
unit, or a Solo E1 Ensemble Shelf plug-in module.
Allocating Contiguous Timeslots
You should be in Menu-6 Timeslot ConÞguration with the cursor in the
Þrst Þeld,
Allocation Type.
To allocate contiguous timeslots to a port, follow the method in the
example below.
Example: To allocate contiguous timeslots 1 through 14 to Data Port 1
use the following steps:
1 To select Contiguous for the allocation type.
Ñ Press
Return to put Allocation Type in edit mode.
Ñ Cycle to
Contiguous, using the Up or Down Arrows,
press
Return to select it and y to conÞrm your action.
DATA01 TS01-TS31 1536Kb/s