User`s guide

3-10 DL600E E1 Data Multiplexer UserÕs Guide
¥ Parameters of the Data and AUX E1 ports in Menu-5 Data Port
ConÞguration
¥ Timeslot allocations in Menu-6 Timeslot ConÞguration
¥ SNMP parameters in Menu-0 SNMP ConÞg (if required)
¥ Alarm conditions, thresholds, and passwords in
Menu-7 Alarm
I
and Menu-8 Alarm II
About the Remote System
The status and conÞguration of the remote system appear on the menuÕs
right side if the remote and local systems have an In-Band
Communication Link over a national bit. The local DL600E unit
continuously polls the remote system for information and displays it on
the screen. If the remote system stops responding for 30 seconds, its
status and conÞguration do not appear on the menu; they reappear when
the system responds.
Setting the Unit ID, Date and Time
Use Menu-4 Main ConÞguration to set the ID, date and time.
SW Ver 1.0 MIB Ver 1.1 Digital Link DL600 Encore 2/24/96
HW Ver A Menu-4 Main Configuration 22:04:06
Local: Remote: MAUI
UNIT Protect Mode
Disabled Disabled
NET CRC4 Enabled Enabled
Line Impedance 120 OHM
Main/Alt Sync. INT/INT NET/int
In-Band Communications Bit 44
AUX CRC4 Enabled
Line Impedance 75 OHM
0-SNMP Config.1-Main Status 2-Data DTE Status 3-Reports 4-Main Config.
5-Data Port Config. 6-Timeslot Config. 7-Alarm I 8-Alarm II 9-Diagnostics
Type Arrow keys to move the selection, RETURN to change a selection
or type 0 through 9 for a new menu:
Figure 3-2 Menu-4 Main ConÞguration
OAHU
Date
Time
Unit ID
These parameters
with an AUX port
appear only on a unit