User`s guide

Installing the DL600E Unit 2-7
Connecting to a DTE Device and the Network
To connect the DL600E unit to a DTE device and to the network, refer
to Figure
2-2 and use the following procedure:
Figure 2-2 DL600E Rear Panel Showing Network Connections
1 Connect the data port interface cable to the DL600E DB25
socket connector (labeled DATA) and to the DTE device.
2 Connect the network port interface cable to the DL600E
socket DA15 connector (labeled NET) and to the E1 cable.
or
Connect a BNC network port interface cable to the two
DL600E BNC connectors (labeled RX and TX).
Warning! Do not connect a cable to the BNC connectors and
the DA15 connector at the same time! It may damage the unit.
COMM EXT CLOCK
DATA 1
DATA 2
NET
AUX
DATA 3DATA 4
NET
RX TX
AUX
RX TX
CAUTION:
WHEN AC POWERED SAFETY REQUIRMENTS ARE NOT
FULFILLED UNLESS EQUIPMENT IS CONNECTED TO A WALL
SOCKET OUTLET WITH PROTECTIVE EARTH CONTACT