User`s guide

Factory Default ConÞguration A-7
Factory Default ConÞguration
The DL600E factory default settings are listed below.
Unit ConÞguration
Unit ID Unique ID assigned Protect Mode Disabled
Network ConÞguration
CRC4 Enabled In-Band Communications Bit
Main Synch. Source Network Alternate Synch Source Internal
Data Port ConÞguration
Loss DTR Format X.21
Mode
DCE
Clock
SCTE
Timeslot Allocation
Allocation Type Contiguous All Bandwidth Allocated to DATA01
Diagnostic ConÞguration
User Pattern 1 001100110011001100110011
User Pattern 2 000000010000000100000001
Alarm ConÞguration
Block All Alarms Disabled Loss of Signal from data port Enabled
Net Carrier Loss Alarm Enabled Net Sync Loss Alarm Disabled
Net UA1 Received Alarm Enabled CV Threshold Alarm Disabled
Net RAI Received Alarm Enabled CRC Threshold Alarm Disabled
SNMP ConÞguration
IP Address 0.0.0.0 IP Subnet Mask 0.0.0.0
1st NMS Address 0.0.0.0 2nd NMS Address 0.0.0.0
3rd NMS Address 0.0.0.0 Set Community String public
Get Community String public TRAP Community String public
Forward over JBC Disabled Output Port Comm
Comm Port and Terminal ConÞguration
Connection In-Band Communications Phone Number 2 Not Assigned
Timeout when not Logged on Unlimited Phone Number 1 Not Assigned
Timeout when not Logged on Unlimited Normal User Password Not Assigned
Comm Port DCD Disabled Superuser Password Not Assigned
Comm Port XON/XOFF XOFF until XON
Comm Port 9600, 8, no parity, 2 stop bits