User guide

Configuration 3-23
3
Table 3-8 describes the parameters of Figure 3-10.
Table 3-8 Menu-8 Alarm II Parameters
Parameter
(Default) Settings Description
Connection
(Direct)
Direct
Modem
In-Band Comm
Direct—connection through a null modem
Modem—connection through a modem
IBC—connection through IBC.
Timeout When Logged On
(Unlimited)
1 min
10 min
30 min
Unlimited
Select a time option. Applies only when you are
logged on. If the Solo E1 DSU does not detect
terminal activity after the specified time span has
elapsed, the Solo E1 DSU
warns that log off is in
30 seconds.
Timeout When Not Logged On
(Unlimited)
1 min
10 min
30 min
Unlimited
Select a time option. Applies only when you are
connected through a modem and not logged on.
When the Solo E1 DSU does not detect terminal
activity when the specified time span has elapsed,
the Solo E1 DSU closes the connection.
Recommend—1 min
Phone Number 1
(empty text string)
Enter a unique, valid Hayes-modem dial string.
Phone Number 2
(empty text string)
Enter a unique, valid Hayes-modem dial string. If
this fails, the Solo E1 DSU waits five minutes then
automatically tries the first number and repeats this
pattern until connected.
Normal User Password
(empty text string)
Use a unique text string. Enter a password (10
characters maximum, case sensitive). As you type,
asterisks appear.
Superuser Password
(empty text string)
Use a unique text string. Enter a password (10
characters maximum, case sensitive). As you type,
asterisks appear.
COMM Port DCD
(Disabled)
Enabled
Disabled
Enabled—drops DCD (Data Carrier Detect signal)
to close the connection. If your modem does not
use DCD, set to Disabled.
COMM Port
XON/XOFF
(Disabled)
Disabled
XOFF until ANY
XOFF until
XON
Disables XON/XOFF.
Use Ctrl-S to stop data flow from remote Solo E1
DSU, and any key to resume flow.
Use Ctrl-S to stop data flow from remote Solo E1
DSU, and Ctrl-Q to resume flow.