User guide

Configuration 3-9
3
3. Use the arrow keys to move to the ID Þeld.
4. Press the Return key to start edit mode.
The Þeld blinks and at the bottom of the screen you will type a unit
ID when this prompt appears.
Please Enter an ID [6 characters max]:
The ID accepts up to 6 alphanumeric characters but cannot begin
with a number. The default ID is a version of the Solo E1 DSU serial
number.
5. Press the Return key, then you will be prompted with the
following:
Do you really want to change the Configuration [Y/N]?
6. Type y to accept the new ID.
Setting Date or Time
To set the date and time:
1. Move to the date Þeld using the right arrow or r key. Use the
up or down arrow key to move between date and time.
2. Press Return to activate edit mode.
Please enter a date [mm/dd/yy]
Please enter a time [hh:mm:ss]
3. Type the date or time.
For example, entering 8/16/94 yields 08/16/94 or 2:46:7 yields
02:46:07 (The clock is a 24-hour clock.)
4. At the prompt, press y to set the date or time. You must use the
right or left arrow key to move out of this feature set.
Configuring Network Parameters
Net Framing needs to match settings on local and remote, otherwise the
remote unit settings are not visible. The factory setting is set to CRC4
enabled.
NOTE: The menu clock is reset to a predetermined value each time
you power up or a reset after a software download. After power
interruption or reset, you must reset the correct time and date.