User guide

3-2 Solo E1 DSU User Guide—June 1998
3
Log On from a Terminal
When you log on for the Þrst time, use the following steps:
1. Press Ctrl-X, type the unit ID, and press Return.
The screen will not reßect this information as it is typed.
If the module is password protected and no other user is logged on,
you are prompted with a message similar to:
Current Unit ID is MAUI.
Now you need a password to log in:
If there is no password protection, Menu-1 Status will automatically
launch (always occurs with a new installation).
2. Type in the password, and press Return.
Menu-1 Main Status appears. If there is no response, you may have
an incorrect ID or a bad COMM port connection.
Log On Through Telnet
The Solo E1 DSU may or may not have a user logged on. To log on through
telnet (when no other user is logged on):
1. Enter the telnet command and the IP address of that Solo E1
DSU.
Example of system response:
Current Unit ID is MAUI.
Now you need a password to log in:
2. Enter the normal or Superuser password.
For Superuser/normal user information refer to ÒUser And
Superuser Log On RightsÓ on page 3-4.