User guide

3-1

ConÞguration 3

This chapter provides procedures to set up the Solo E1 DSU:

¥ ÒLogging On and OffÓ on page 3-1

¥ ÒAccess RightsÓ on page 3-3

¥ ÒUsing The Terminal InterfaceÓ on page 3-5

¥ ÒBasic Parameters Using Menu-4 Main ConÞgurationÓ on page 3-7

¥ ÒMenu-8 Alarm II ConÞgurationsÓ on page 3-19

Logging On and Off

The conditions for logging on differ when the Solo E1 DSU terminal

interface is free or when another user is currently connected.

Systems with blank IDs are always logged on and cannot be logged off

until you assign a unit ID to that Solo E1 DSU. (Refer to ÒBasic Parameters

Using Menu-4 Main ConÞgurationÓ on page 3-7).

Use one of these two methods to log on to the Solo E1 DSU:

¥ From a terminal (directly or through a modem)

¥ From a remote terminal through a telnet connection

The Unit ID

To log on to a Solo E1 DSU, press Ctrl-X, and enter the unit ID of that

Solo E1 DSU.

To display the unit ID of the Solo E1 DSU, press Ctrl-X Þve times. The

unit ID appears on the left side of the screen. (For Þrst time setup, the unit

is usually factory conÞgured with an alphanumeric number.)

If the ID does not appear, check the COMM port conÞguration and

connection.

NOTE: To reset the unit to factory conﬁguration, press and hold the

three buttons located on the front of the unit for 10 seconds.