User guide

2-18 Solo E1 DSU User Guide—June 1998
2
Installing the Module
To install the module:
1. Check the contents of the shipping carton.
Check for visible damage to the shipping carton and to the module.
2. Get and wear a static wrist strap.
To prevent static electricity from damaging the module.
3. Open the anti-static wrap and withdraw the module.
4. Set the jumper settings (refer to Figure 2-7 and Table 2-9).
5. Insert the module into any open slot in the shelf.
From the front of the shelf, all empty slots except the far right slot
(reserved for the controller or MAP module).