User guide

2-1

Installation 2

This chapter describes installing the Solo E1 DSU Standalone and module:

¥ ÒPre-Installation ChecksÓ on page 2-1 (apply to both the Solo E1 DSU

and module)

¥ ÒTerminal and DIP Switch ModeÓ on page 2-2

¥ ÒCable RequirementsÓ on page 2-2

¥ ÒInstalling the Solo E1 DSU StandaloneÓ on page 2-3

¥ ÒInstalling The Solo E1 DSU ModuleÓ on page 2-17

Pre-Installation Checks

Before installing the Solo E1 DSU or module, check the shipping

package(s) and prepare the network information and the installation site.

Check the Package(s)

¥ Unpack and inspect the Solo E1 DSU for damage that may have

occurred during shipment.

¥ Save all enclosed packing slips and documents. Save shipping cartons

and packing materials until you have completed the installation and

veriÞed device operation.

¥ Verify that all equipment ordered matches the packing slip. If the

equipment does not match your order, contact Digital Link Customer

Support.

¥ Fill out and mail the registration card.

Prepare Network Information

Request the following information from your network administrator before

you install the Solo E1 DSU:

¥ Solo E1 DSU IP addressÑTo enable a Telnet connection to the Solo E1

DSU from a remote terminal.

¥ To use SNMP network management, one to three NMS IP addresses in

addition to the above IP address. These addresses are where the Solo E1

will send traps.