User guide

Software Download E-5
E
Table E-1 describes the parameters of Figure E-3.
Table E-1 Download Utilities Groups
Group Field Description
CODE FILE 1 Version Version of the operational software in Code File 1. This field displays:
• Cur, for current operational software, with the version
• Absent, if there is no operational software stored
CODE FILE 2 Version Version of the operational software in Code File 2. This field displays:
• Cur, for current stored software, with the version
• Absent, if there is no operational software stored
DOWNLOAD Code File
Status
Error
Bytes Received
Protocol
The Code File that will receive the downloaded operational-code, and
that is currently not operational.
Shows the status of the download. This field shows either Success,
Failed, or In Progress. Status is idle when no download is taking place.
If the operation fails, a number indicates the specific problem of the
failure.
Shows an error code if a failure occurs.
Shows the number of bytes received during a TFTP download.
Download protocol. Choices are XMODEM and TFTP.
CHANGE Code File
Method
Scheduled Date
Scheduled Time
Count Down
Code File to be switched over when the scheduled time is reached.
Choices are NONE, 1, and 2. NONE indicates that no change is
desired, and can be used to cancel a scheduled change.
Either SCHEDULE or NOW. NOW: change occurs immediately;
SCHEDULE: change occurs when the actual time reaches the scheduled
time.
Expressed in mm/dd/yy (month/day/year) at which the switch-over
will occur.
Expressed in hh:mm:ss (hours:minutes:seconds) at which the switch-over
will occur.
Shows the time interval hh:mm:ss (hours:minutes:seconds) for the switch-
over to occur after it has been initiated. If the switch-over has not been
initiated, then it shows “Press 2 To Start” or “Press 4 To Start” for the
local and remote Solo E1 DSU, respectively.