User guide

Software Download E-3
E
3. Arrow down to the Forward Over IBC Þeld and make sure it is
set to enabled.
Now proceed to Menu-4 and follow the steps for TFTP set up.
Figure E-2 Remote connection over IBC
Initiating TFTP
1. From Menu-4 Main ConÞguration (Figure E-1), type F (as
instructed in the Menu-4A (Figure E-3) for FLASH Download)
to start the download session.
2. Set Protocol to TFTP.
3. Type 1 to initiate the local download, or type 3 to initiate
remote download over IBC.
4. Start the TFTP transfer from the workstation.
The Solo E1 DSU supports TFTP PUT. TFTP download requires binary
mode and TFTP PUT.
From a UNIX workstation, the command sequence is:
# tftp ip_address_of_target_unit
# bin
# put filename
SLIP connection
IBC
Local DSU
Remote DSU
E1 Payload