User guide

E-2 Solo E1 DSU User Guide—June 1998
E
¥ Downloading code.
Figure E-1 Menu-4 Main Config.—Flash Download
Setting Up for TFTP
The procedures for local or remote TFTP download are the same, except
when you do not have a SLIP or telnet connection to a unit. The local unit
is always the unit you are logged into and itÕs parameters appear on the
left side of the screen. The remote E1 parameters appears on the right side
of the screen.
If you do not have a SLIP or telnet connection to a remote unit, you need to
perform the following steps before proceeding to set up for a TFTP.
1. Connect via SLIP or telnet to the local unit.
2. Go to Menu-0 (see Figure 3-6 on page 3-16) to set up the IBC
connection (IBC runs over a netlink). (Figure E-2)
NOTE: Before beginning any upgrade, you need to create a new
directory on your hard drive and load the new code on to the PC.