User guide

Terminal Interface 4-33
4
SNMP Configuration
Through the SNMP CONFIGURATION MENU, the user conÞgures the
Network Manager (NMS) port on the rear panel of the DL3800, setting
various addresses and conÞgurable items required for operation with an
SNMP Network Manager. The DL3800 utilizes SLIP protocol over the
RS232 port to communicate with the SNMP management station.
To access the SNMP CONFIGURATION MENU, move the highlight bar to
SNMP CONFIGURATION in the CONFIGURATION MENU, and press Enter.
Figure 4-16 is an example of the SNMP CONFIGURATION MENU, and
Table 4-9 describes the SNMP parameters:
Figure 4-16 SNMP CONFIGURATION MENU
Table 4-9 SNMP Configuration Options
Option Description/Action
Unit IP Address The Unit IP Address is a 32-bit quantity which uniquely identifies the node in
the IP network. This address is used by the SNMP manager to access
information from the node.
To set or change the Unit IP Address, move the highlight bar to Unit IP
Address, and enter a 32-bit quantity. Press Enter when finished.