User`s guide

Conﬁguring the DL3100 4-25

Conﬁguring the HVDB

You use the HVDB ConÞguration and Connections Menu to conÞgure the

HVDB.

To access the HVDB ConÞguration and Connections Menu, select the

HVDB device from any main menu. Next select ConÞguration &

Connections from the HVDB Main Menu and press Return.

Figure 4-12 shows an example of the HVDB ConÞguration and

Connections Menu.

Figure 4-12 HVDB Conﬁguration and Connections Menu

The HVDB conÞgurable parameters are the same as those of the HSDB

with the exceptions of CTS Control and TD Clock. These parameters are

deÞned as follows:

HVDB Conﬁguration and Connections Menu Parameters

The HVDB ConÞguration and Connections Menu parameters are as

follows:

¥ CTS ControlÑAssert CTS or Auto CTS (DefaultÑAssert CTS)

Assert CTSÑWhen this feature is enabled the CTS (clear to send) signal

is always sent to the DTE regardless of the status of the RTS signal.

Auto CTSÑSelect this mode to activate CTS when RTS is active and

either a loop is in progress or the DTE is connected to the T3.