User`s guide

4-6 DL3100 User’s Guide—November 1998
4
5. Type the node number and press Return.
You will see the prompt:
User name:
6. Enter a valid user name. If a user name has not been conÞgured,
press Enter to bypass this Þeld.
The following prompt appears:
Password:
7. Enter a valid password. If a password has not been conÞgured,
press Enter to bypass this Þeld.
The Node/T3MB Main Menu appears. (Figure 4-3.)
If it does not appear, you may have an incorrect node number, a bad
connection on the comm port or a bad comm port conÞguration.
8. To log on to another DL3100 on the same daisy chain, press Ctrl-
X, then type the pound sign (#) followed by the node number.
Press Return.
To log off all units, press Ctrl-X and press Return.
Using the Terminal Interface
The DL3100 terminal interface contains a number of menus which you use
to conÞgure, monitor and manage the DL3100.
When you log on, the Node/T3MB Main Menu appears.
To select a submenu, move the highlight bar through the menu screen
using the up and down arrows. When the desired menu is highlighted,
press Return.
Press Escape to bring the display back to Select Device when in the main
menus, and back to Exit when in the execution menus.
To exit any menu and return to the Node/T3MB Main Menu, select Exit
and press Return.
To redraw a screen, press Ctrl-L.
Selecting a Device
Before performing any activities, you must Þrst select a device. You can
select a device from any of the main menus.
To select a device from a main menu: