User`s guide

1-1
1
DL3100 Quick ConÞguration 1
This chapter is intended for more experienced users who wish to have a
quick reference for the DL3100 conÞguration. It is assumed that you are
familiar with the DL3100.
ConÞguring the DL3100 is simple and easy. It should take less than Þve
minutes with a little information and this quick conÞguration chapter. This
chapter is meant to conÞgure only critical items. If any options are not
mentioned, leave them at the factory default.
For any options(s) not discussed in this chapter or for further information
on the DL3100, refer to the remaining chapters and appendices in this
guide or contact Digital LinkÕs Technical Assistance Center:
Required Pre-Configuration Information
1. Does the DTE (router) use a HSSI or V.35 interface to transfer data to
and from the DL3100?
2. At what speed (300 kbps-44.2 Mbps) should the DTE port be clocked?
3. Is there a cable to connect the DTE and DL3100?
4. Is the port on the DTE device powered up, attached, conÞgured, and
active?
5. What is the T3 (DS3) framing format (M13 or C-Bit)?
6. Is the T3 (DS3) carrier providing timing?
7. Has the circuit been cut-over and tested end-to-end?
Telephone [phone]
FAX [phone]
E-mail [e-mail]
Hours 24 hour service, 7 days a week