User`s guide

7-16 DL3100 User’s Guide—November 1998

¥ CUR345

Counts the number of errors in the current interval for that performance

¥ TOTL.679

Counts the number of seconds in error or the number of errors for that

performance statistic over the past 24 hours, or since the registers were

last cleared.

¥ (1 - 96) =900

Counts the number of seconds in error and the number of errors for that

performance statistic during the most recent 15-minute interval.

For example:

34 = 42

The number to the left of the display signiÞes the 15-minute interval

represented (1 to 96). The number to the right is the number of errors

(maximum of 900) occurring during that period.

Continue to press the down arrow to view subsequent intervals.

Clearing Network Statistics

The NET CLR STAT is the last entry in the Net Statistics Menu. You use

NET CLR STAT to clear all network statistics.

To clear all the network statistics, press ENTR at the NET CLR STAT

display. To conÞrm the action, press ENTR again when the display is

blinking, or press EXIT to take no action.

For more information about network statistics, see ÒMonitoring Network

StatisticsÓ on page 5-14 in Chapter 5, ÒMonitoring and Managing the

DL3100.Ó

Monitoring HSDB/HVDB Statistics

You use the HSDB or HVDB (1, 2, or 3) Statistics Menus to view and clear

the DTE performance statistics.

The illustration below shows the parameters that you can view from the

HSDB/HVDB (1, 2, or 3) Statistics Menu, using an HSDB DTE. However,

the parameters are the same for HBDV devices.