User`s guide

7-12 DL3100 User’s Guide—November 1998
7
4. Press ENTR to activate edit mode.
The display starts to blink.
To take no action and move to the next item, press EXIT.
Press the up or down arrow to select either In Service or Out of
Service and press ENTR to conÞrm the option selected.
5. Use the same method to conÞgure the other parameters in the
HVDB Menu for this data port. Repeat for any other HVDB data
ports.
HVDB Config Menu Parameters
The following is a list of the HVDB ConÞg Menu parameters:
¥ DTE rate
Lets you select DTE rates in increments of 300 kbps ranging from 300
kbps to 44.2 Mbps. The maximum data rate recommended for V.35 is 4
Mbps.
¥ Service
Lets you place the HSDB In Service or Out of Service.
¥ CTS
Lets you assert Clear To Send (Assert CTS) so that it is always sent to
the DTE in response to an RTS.
¥TD
Lets you determine whether the transmit clock is to be received from
the DTE leads (SCTE) or from the DL3100 (SCT).
¥ Clock
Lets you set the TD clock to normal or inverted.
¥ Delete DTE
Prohibits the data board from recognizing the DTE.
For more information regarding these parameters, refer to ÒConÞguring
the HVDBÓ on page 4-25 in Chapter 4, ÒConÞguring the DL3100.Ó
Displaying Status and Statistics
You use the Display Menu to monitor network status, node status, and
network and HSDB/HVDB statistics.