User`s guide

7-10 DL3100 User’s Guide—November 1998
7
Configuring the Data Ports
You use the HSDB (1, 2, or 3) ConÞg and/or the HVDB (1, 2, or 3) ConÞg
Menus to conÞgure your data ports. Refer to ÒConÞguring the HSDB and
the HVDBÓ on page 4-21 in Chapter 4, ÒConÞguring the DL3100Ó for a
description of the parameters.
Configuring the HSDB
Follow these steps to conÞgure the HSDB:
1. From the ConÞguration menu, press ENTR and open HSDB (1, 2,
or 3) CONFIG using the up or down arrows. Press ENTR.
DTE FREQ xx.x MB appears.
2. To activate edit mode, press ENTR again.
DTE FREQ xx.x MB starts to blink.
To take no action and move to the next item, press EXIT.
Press the up or down arrows to cycle through the available options
and press ENTR to select an option.
3. Press the down arrow to move to the next parameter, Use
Divided/Full Clock.
4. Press ENTR to activate edit mode.
The display starts to blink.
(Or press EXIT to take no action and move to the next item)
Press the up or down arrows to select either Full Clock or Divided
Clock and press ENTR to conÞrm the option selected.
5. Use the same method to conÞgure the other parameters in the
HSDB Menu for this data port. Repeat for any other HSDB data
ports.
HSDB Config Menu Parameters
The following is a list of HSDB ConÞg Menu parameters:
¥ DTE rate
Lets you select DTE rates in increments of 300 kbps ranging from 300
kbps to 44.2 Mbps.