User`s guide

Using the Front Panel Interface 7-9
7
4. To edit the ID, follow the procedure given in ÒEditing a
ParameterÓ on page 7-4.
5. Enter the Node Comm Port submenu using the down arrow to
select it and press ENTR.
BAUD RATE 9600 appears.
Press ENTR to activate edit mode. (BAUD RATE 9600 blinks.)
6. Cycle through the available baud rate options using the up or
down arrows and press ENTR to select an option, or press EXIT to
exit without executing the baud rate change.
7. To move to the next comm port parameter, press the up or down
arrow.
Edit the remaining comm port parameters as previously discussed.
The T3 Net Config Menu
The Net ConÞg Menu contains the following items:
Figure 7-8 T3 Net Config Menu
For more information about these items, refer to ÒConÞguring the T3MBÓ
on page 4-16 in Chapter 4, ÒConÞguring the DL3100.Ó
T3 NET CONFIG
ENTR
SCRAMBLER DISBAL
CBIT FRAME FMT
NETWORK CLOCK
APPL. LINK NRZI
IN SERVICE
NEAR LBO (<225)
GR500
EXIT