User`s guide

5-26 DL3100 User’s Guide—November 1998
5
2. Execute the emulation program on the PC and set it up to match
the DL3100 comm port settings.
3. To begin downloading, you must be logged on to the selected
DL3100.
Select Software Download from the Node/T3MB Main Menu.
To refresh the screen, use Ctrl-L.
4. To select the download mode, highlight the Download Protocol
Þeld and use the Space Bar to cycle through the options. Press
Return at the desired option.
The options are Binary image with Kermit, Binary image with
XMODEM, Motorola S-Records with ASCII Transfer, and None.
A message appears reminding you that you must conÞrm the change.
5. Select ConÞrm and press Return.
6. Start the download from the emulation program.
This can take up to 20 minutes at a 9600 baud rate. When it is
completed, the DL3100 automatically reboots.
You may need to perform the download again if any communications
errors are encountered. To Þnd out if the download has been successful,
log into the DL3100 and check the software revision number. If the
software revision number has been updated, the download is complete.
Deleting the Entire Node Configuration
You can perform three tasks from the Delete Entire Node ConÞguration
Menu:
¥ Delete RAM Code and Revert to ROM Code
This operation deletes any software downloaded to the unit. The unit
reverts to the initial software it received at the factory.
¥ Restart Node Software
This operation is equivalent to turning the power on and off. The last
saved database remains unchanged.
NOTE: The DL3100 configuration may be lost during this operation.