User Manual

ManualsBrandsDigital Juice ManualsLight StandsAura Light Stand

Getting Started Guide (continued)

1) Unpack the three light fixtures,

power cords and light stands from

the deluxe carry bag (9).

2) Remove the light stands from their

cloth carry bags (10) and unfold

the tripod legs, setting the height

of the light stand as desired using

the screw knobs to adjust and lock

down the length of each spring

loaded section (11).

3) Attach the power cord to each

Aura fixture and then mount each

light to the top of a light stand by

sliding the end of the gooseneck

arm over the top mounting stud

and tightening the knob (12).

4) Adjust the position of each Aura

light by bending the gooseneck

arm as required (13). Plug in the

lights and you are ready to shoot.

Note: The Aura light fixtures are also

lightweight and compact enough to

use in a variety of other mounting

situations when there is not enough

room to use a light stand. They can be

attached to an available shelf or wall,

for example, using an articulating arm/

mini clamp combination or a suction

cup mount. Because they run very

cool, they can also be handheld by an

assistant when needed.

Safe Handling & Efficient Use Of Aura Lights

• Avoid turning lights off and on more than necessary during use as

this will reduce lamp life.

• Turn off other lights indoors when shooting in order to avoid

effects on overall color temperature in your shots.

• Use fixtures only with specified voltage and frequency ratings.

• Avoid pulling the power cord to unplug or move the light fixture.

• Do not insert metal objects into the cooling grill holes on back of

fixture.

• Make sure power is disconnected when changing light fuses and

replacing bulbs.

• Discontinue use of the light fixtures if they become damaged. If

only the bulb is damaged it can be replaced. Otherwise, the lights

should be professionally repaired or discarded.

• Do not expose lights to dripping or splashing water and do not use

in wet environments.

1) Wait for the bulbs to cool if they have been in use and disconnect the power

cord from power source.

2) Remove the plastic buckle clip (15) holding the far end of the bulbs in

place. To do this, using two hands, carefully lift both sides of the buckle

clip at the same time, up and outwards, away from the bulb and the lower

half of the buckle fixture (16).

3) Remove the bulb from the lamp socket at the other end of the fixture (17)

and discard safely. Fit the new bulb into the lamp socket, applying a light

pressure to make sure it is seated properly in the socket and fitting the bulb

into the buckle at the other end.

4) Slide the buckle clip back on top of the bulb, snapping it to the bottom half

of the buckle fixture. Start using your Aura light once again.

1) Disconnect the light fixture’s power

cord from power source.

2) Unscrew the FUSE twist knob on

the back of the unit (14) and pull

out the existing worn out fuse.

Install one of the replacement fuses

provided in the light kit by sliding it

into the fuse socket. Rescrew the

FUSE knob tightly. Reconnect the

power and continue use.

Setting Up the

Aura 3-Point Lighting Kit

Replacing Bulbs in Your Aura Light Fixtures

Replacing Lamp Fuses