User Manual

Using the

Free Spirit

Camera Stabilizer

USER’S GUIDE

19 20

Attaching your camera to the Free Spirit

1. Remove the quick release plate from the top of the Free Spirit. To

do this, position the unit with arrow on top of quick release plate

(16) facing away from you, then loosen the quick release lever

knob on the right side (17) and pull on the red back-to-front fine

adjustment screw (18) on the left side of the quick release plate

unit. This will release the lock on the sliding plate and you can

slide it off the top of the Free Spirit in the direction of the arrow.

2. Find the threaded hole on the bottom of camera, and determine the

correct mounting screw to use with it. The Free Spirit quick release

plate features dual 1/4”-20 and 3/8” removable camera mounting

screws, so install whichever of these you need for your camera

through the bottom of the quick release plate’s long slot (19).

3. Screw the quick release plate onto the bottom of your camera.

4. Slide the camera onto the top of the Free Spirit by aligning the

quick release plate with its base and sliding it into place (20).