User Manual

8
USER’S GUIDE
Operating
Your MiniBurst
PRO Lighting
System
a. Attach LED light fixtures to desired mounting locations using either the
included hotshoe swivel mounts, mini ball-head light stand mounts or
any other ¼”-20 mounting accessory.
Caution: When attaching any ¼”-20 threaded stud to the mount-
ing and accessory holes on the MiniBurst lights (26, 27, 36), do
not use excessive force, pliers or any other tools, as there is a
limited depth available to accept the ¼”-20 threaded stud and you
could cause damage to your light which would void your warranty.
b. On the MiniBurst 504 lights, attach one of the included 2600mAh
14.8V Li-ion rechargeable battery packs (2) to the battery plate
(38, 39) on the back of the light or plug the included 18V DC
adapter (4) into the DC Power In (34, 35) on the bottom of the
light to power it.
c. On the MiniBurst 256 light, attach the included 7.4v NP-F type
(6000mAh) battery (3) to the battery plate (29, 30) on the light.
Alternatively, you could plug the included 12v AC power supply
adapter (5) into the DC Power In (24) on the side of the light to
power it.
d. On the MiniBurst 504 lights, power the lights ON by pressing the
power switch/dimmer knob (31). On the MiniBurst 256, power the
light ON with the power switch (23).
e. On the MiniBurst 504, turn the power switch/dimmer knob to
control the intensity of the light. Turning the dimmer knob in a
clockwise direction will increase the intensity and turning it counter-
clockwise will decrease the intensity of its output. The OLED
display to the left of the power/dimmer knob displays the dimmer’s
intensity setting (32, 33, 41) so you can easily and consistently
return to it after each take.
f. On the MiniBurst 256, the dimmer knob (25) can be used to control
the intensity of the light. Turning the dimmer knob in a clockwise
direction will increase the intensity and turning it counter-clockwise
will decrease the intensity of its output.
g. Install Warming (11, 13) or Diffusion (12, 14) filters if needed.
These filters easily mount to the lights via magnetic snap-on
posts on the MiniBurst 504 lights (11, 12, 43) or by sliding into
a bracket on the front of the light on the MiniBurst 256 (13, 14, 44)
Warming filters are used to match daylight balanced LED lights to
warmer tungsten fixtures, while diffusion filters help to soften and
spread the light.
43
44