Operating instructions

MCO-5211
SAFETY COMPLIANCE
This equipment complies with:
EN 60950-1 (2
nd
edition) directive 2006/95/EC
CSA C22.2 No. 60950-1 (2
nd
edition)
UL 60950-1 (2
nd
edition)
The power cord supplied with this equipment meets the appropriate national standards for the country
of destination.
WARNING An appropriately listed/certified mains supply power cord must be used for the connection of the
equipment to the mains voltage at either 120V~ or 240V~. The socket-outlet shall be installed near
the equipment and shall be easily accessible.
Protective grounding of the instrument is required for the accessible terminals to be safe (EN
60950-1).
CAUTION This equipment is meant to be installed in a restricted-access location.
Disconnect power cord before servicing.
These servicing instructions are for use by qualified service personnel only.
To reduce the risk of electric shock, do not perform any servicing other than that contained in the
operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel.
ELECTROMAGNETIC COMPATIBILITY
This equipment has been tested for verification of compliance with FCC Part 15, Subpart B requirements for
Class A digital devices.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
This equipment has been tested and found to comply with the requirements of the EMC directive
2004/108/CE:
• EN 55022 / EN 55016-2-3 / EN 55014-1 Emissions
• EN 55103-2 Annex A and B Immunity
• EN 61000-3-2 Harmonic current emission limits
• EN 61000-3-3 Limitation of voltage changes, voltage fluctuations and flicker
• EN 61000-4-2 Electrostatic discharge immunity
• EN 61000-4-3 Radiated electromagnetic field immunity – radio frequencies
• EN 61000-4-4 Electrical fast transient immunity
• EN 61000-4-5 Surge immunity
• EN 61000-4-6 Conducted emissions immunity
• EN 61000-4-11 Voltage dips, short interruptions and voltage variations immunity