Instruction manual

SYNC-SWITCH - MANUAL 11
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
SYNC-SWITCH – Manual – Rev 1.1 - 11 -
IP Router
Provide the IP address of the router in dotted decimal notation.
VLAN ID
Provide the managed VLAN ID. The allowed range is 1 to 4095.
SNTP Server
Provide the IP address of the SNTP Server in dotted decimal notation.
Ports
This is the page that has to be used in order to configure the port settings such as speed and duplex.
Please note that SFP ports can operate to 2.5 Gbps, but it may not be standard so for maximum compatibility is best to
force 1Gbps FDX operation on the SFP ports.
Port
This is the logical port number for this row.
Link
The current link state is displayed graphically. Green indicates the link is up and red that it is down.
Current Link Speed
Provides the current link speed of the port.
Configured Link Speed
Selects any available link speed for the given switch port. Only speeds supported by the specific port is shown. Possible
speeds are:
Disabled - Disables the switch port operation.
Auto - Port auto negotiating speed with the link partner and selects the highest speed that is compatible with the link
partner.
10Mbps HDX - Forces the cu port in 10Mbps half duplex mode.
10Mbps FDX - Forces the cu port in 10Mbps full duplex mode.
100Mbps HDX - Forces the cu port in 100Mbps half duplex mode.
100Mbps FDX - Forces the cu port in 100Mbps full duplex mode.
1Gbps FDX - Forces the port in 1Gbps full duplex
2.5Gbps FDX - Forces the Serdes port in 2.5Gbps full duplex mode.
SFP_Auto_AMS - Automatically determines the speed of the SFP. Note: There is no standardized way to do SFP auto
detect, so here it is done by reading the SFP rom. Due to the missing standardized way of doing SFP auto detect some SFPs
might not be detectable. The port is set in AMS mode with SFP preferred. Cu port is set in Auto mode.
100-FX - SFP port in 100-FX speed. Cu port disabled.