Instruction manual
MXS-EVO - MANUAL
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
MXS-EVO – Manual – Rev 1.7 - 34 -
The default credentials are:
administrator (read and write) admin / admin
guest (read only) guest / guest
From here, it’s possible to check:
• Presence of the GPS antenna
In the GPS tab of the Main Panel the Antenna led should be green and, after a few minutes from the boot, the
PPS Status led should become green, too.
• Presence of the Ext. Frequency signal
In the Ext tab of the Main Panel the Valid led of the Frequency box should be green. If not do eventually
modify the expected frequency in the GPS/EXT Config Panel.
• Presence of the Ext. Timing signal
In the Ext tab of the Main Panel the Valid led of the Time box should be green.
• Presence of the E1 signal
In the E1 tab of the Main Panel the Signal and Framing leds should be green.
• Presence of the PTP signal
In the PTP tab of the Main Panel the Enabled led should be green and Status should display Slave.
• Presence of the IRIG-B signal
In the IRIG-B tab of the Main Panel the Present led should be green and Date should display a valid date.
Automatich switchover
In order to enable the automatic switchover is better to first check a few settings:
• Switchover policies
It is possible to set different policies for the switch.
These policies can be set from the front panel (Board Settings
Policy), from SNMP (policy) or from WEB in
the Board Configuration page.
• Switchover treshold
It is possible to set a treshold to wait before switching to another source.
These policies can be set from the front panel (Board Settings
Switchover), from SNMP (switchover) or from
WEB in the Board Configuration page.
• Disciplining mode
It is possible to specify if the disciplining from the external frequency or from E1 has to be done in frequency
or phase.
• Automatic switchover
To finally enable the automatic switchover is possible to operate from the front panel (Board
Settings
Manual/Auto), from SNMP (switchMode) or from WEB in the Board Configuratio page.