Instruction manual

MXS-EVO - MANUAL
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
MXS-EVO – Manual – Rev 1.7 - 29 -
Profile
Allows to choose to choose between some predefined profiles for common configurations.
Multicast/Unicast
Allow to choose the type of communication mechanism.
IP Dest
Allows to define a series of additional unicast addresses.
Advanced
Allows to configure a set of advanced settings.
Intervals
The various interval values are expressed in power of 2, so 0
corresponds to 1 second, 1 to 2 seconds and -1 to 0.5 seconds.
VLAN
Allow to enable or disable the 802.1Q protocol.
Follows a comparative table of the various profiles. In order to customize
some specific values a CUSTOM profile must be chosen.
DEFAULT TELECOM POWER
Sync
1/s 32/s 1/s
Announce
2s 8/s 1/s
Announce timeout
12s 0.25s 6s
Delay Request
8s 32/s -
Peer Delay Request
- - 1/s
Delay Mechanism
E2E E2E P2P
Domain Number
0 4 0
Encapsulation
UDP UDP Layer2
Routing
MULTICAST UNICAST MULTICAST
IRIG-B
The only two settings related to the IRIG-B block are the input selector (IRIG-B Mux) and the Timezone.
NTP
Mute
Do not reply to any NTP request before synchronization is completed and time reference is valid.
If the time reference is invalid the clock unsynchronized is risen, but some clients may not check the flag and
blindly trust the time value. This setting is for additional safety.
Hardware
Enable NTP hardware timestamping support for improved performance (disables PTP)
Broadcast
Periodically send broadcast NTP server packets (without authentication)
Poll
Specify the interval between broadcast packets