Instruction manual

MXS-EVO - MANUAL
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
MXS-EVO – Manual – Rev 1.7 - 23 -
Board Config Panel
Source
Permits to force a switch on a different source when the device is configured in manual switch mode.
To switch from the WEB interface just go the the View tab of the Main Panel and click on a source.
Manual/Auto
Allows to set the type of switching (manual or automatic).
Disciplining Mode
Selects the kind of tuning to use when discipling from da EXT or E1 reference.
The frequency tune is faster, but loses the phase alignment of the PPS provided in output.
Policy
Indica la politica attualmente utilizzata per la commutazione in modalità automatica. Per avere maggiori
Indicates the policy used to do switchovers. Toh ave more details on the subject please consult the relative
section Switchover Policies.
Switchover
Allows to modify the switch-over time. For more details please consult the relative section Switchover.
Priority
Set the priority of each source for the automatic switch (a higher value means a higher priority, 0 disables
the source).
PPS Mute
Inhibits the output of the PPS until the device has reached a synchronized status (tipically a few minutes
are needed).
PPS
Allows to choose which signal to spread on the PPS connectors (default is board PPS).
IRIG-B IN
Permits to choose the source of the IRIG-B input signal (BNC or OPTICAL)
IRIG-B OUT
Allows to choose which signal to spread on the IRIG-B BNC connectors (default is IRIG-B).
Positioning
Permits to change the position of the device (retrieved from GPS if available).