User manual

User Manual Page 84
EDIsecure
®
XID 8300 Printer Driver
Step 6: Exchange the card sides
As seen in the last step, for non-blank cards, the position of the magnetic stripe or contact chip or both must
be adjusted to fit the layout. While the Rotation-button rotated the card on both sides, the Exchange-button
allows to swap the front and back sides if the magnetic stripe or the chip is shown at the wrong side of the
layout.
Magnetic stripe:
The stripe can either be on the front or the back side of the layout.
Contact chip:
The chip can either be on the front or the back side of the layout.
The following illustrations show some examples of magnetic stripe and chip cards and a combination of both
types and the effect of the rotate-button.
Note:
The same applies for one-sided cards.
Magnetic stripe Contact chip
+ +
+ +
Magnetic stripe + contact chip
+
+