User manual

User Manual Page 83
EDIsecure
®
XID 8300 Printer Driver
Step 5: Rotation of the card
For non-blank cards, the layout design must cope with either the contact chip or the magnetic stripe or both
on each side of the card. In the layout, these areas are usually left blank and the Rotation-button allows the
print to match the layout, i.e. to place the elements in the correct positions as they were intended during
layout creation.
Magnetic stripe:
The stripe can either be on the top or the bottom of the layout.
Contact chip:
The chip can either be on the left or the right side of the layout.
Important:
The rotation button will rotate the card, so both, the position of either chip or magnetic stripe will rotate on
both sides of the layout.
The following illustrations show some examples of magnetic stripe and chip cards and a combination of both
types and the effect of the rotate-button.
Note:
The same applies for one-sided cards.
Magnetic stripe Contact chip
+ +
+ +
Magnetic stripe + contact chip
+
+