Instruction manual

Instruction Manual Page 9
EDIsecure
®
XID 8300 Ethernet Status Monitor
2.3 List of Status Messages
No.
Displayed Message
Description
1
No printer is found
The power of the printer is not turned on, or the
host computer is not properly connected to the
printer.
2
Ready
The printer is in the ready mode. The printer is
ready to start printing cards.
3
Initializing
The printer is initializing. The printer switches to
the Ready mode after initialization is complete.
4
Offline Mode
The printer is in the setting mode, or roller
cleaning is in progress. When this is complete,
the printer switches to the Ready mode.
5
Preheating
Preheating of the heat roller is in progress. The
printer switches to the Ready mode upon
reaching an appropriate temperature.
6
Card Loading
7
Card Transporting
8
MG Encoding
9
Retransfer
10
Contact IC Encoding
11
No-Contact IC Encoding
12
Printing
The printer is issuing cards. The printer’s
operating status when issuing cards is
displayed. After card issuance is complete, the
printer returns to the Ready mode.
13
Power Saving
The printer is in the Power Saving mode, which
helps to reduce power consumption. To exit the
Power Saving mode, press the Reset button,
followed by the Enter button to initialize the
printer.
2.4 Displaying Media Status
 Media Status: Displays the media’s remaining space available.
 Card Quantity: Displays the remaining card quantity as three different levels as shown below.
The display may vary according to the thickness as well as bend of the card.
Card Quantity Display
Card Thickness of 0.76 mm
Card Thickness of 0.25 mm
Enough
Approx. 25 cards or more
Approx. 70 cards or more
Less
Less than 25 cards
Less than 70 cards
None
No card
No card
 Ink Quantity: Displays the remaining ink ribbon quantity in 50 different levels in percentage.
 Film Quantity: Displays the remaining retransfer film quantity in 10 different levels in
percentage.
Caution: The remaining quantity shown is an estimated value. Differences may occur according
to the usage as well as media type.
 Ink:
Displays the information on the mounted ink ribbon. The print counter appears blank if the ink ribbon
is not correctly recognized. You may not be able to control the ink ribbon properly in this case. Refer
to the “Setting the ink ribbon” of the “XID 8300 Instruction Manual” (separate booklet) on how to check
its installation.