Instruction manual

Instruction Manual Page 30
EDIsecure
®
XID 8300 Ethernet Status Monitor
Error Code
Displayed Message
Actions
printer power till it becomes cool
enough.
roller has gone down.
Call for servicing if this problem recurs.
0104F100
Hardware failure of Retransfer Roller
happens. Please turn off and on the
printer power to initialize the printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104F200
Hardware failure of Retransfer Roller
Thermistor happens. Please turn off
and on the printer power to initialize
the printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104F300
The temperature of Bend Remedial
Roller is too hot. Please turn off the
printer power till it becomes cool
enough.
Turn off the power of the printer. Turn on
again after the temperature of the bend
remedy roller has gone down.
0104F400
Hardware failure of Bend Remedial
Roller happens. Please turn off and
on the printer power to initialize the
printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104F500
Bend Remedial Roller thermistor is
out of order. Please turn off and on
the printer power to initialize the
printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104F600
The temperature in the printer is too
cool. Please turn off the printer power
till it becomes warm enough.
Turn off the power of the printer. Turn on
again after allowing the surrounding
temperature of the printer to rise.
Call for servicing if this problem recurs.
0104F800
The temperature of Thermal Head is
too hot. Please turn off the printer
power till it becomes cool enough.
Turn off the power of the printer. Turn on
again after the temperature of the thermal
head has gone down.
Call for servicing if this problem recurs.
0105FB00
Download data to the printer is
invalid. Please confirm the file is
correct.
Check to ensure that the downloaded file is
correct.
0142A200
End of Retransfer Film; please
replace the film with a new one.
Replace the retransfer film. After doing so,
close the printer door, followed by pressing
the RESET and ENTER buttons in sequence
to initialize the printer.
0142B200
End of Ink Ribbon; please replace the
ink ribbon with a new one.
Replace the ink ribbon. After doing so, close
the printer door, followed by pressing the
RESET and ENTER buttons in sequence to
initialize the printer.