Instruction manual

Instruction Manual Page 29
EDIsecure
®
XID 8300 Ethernet Status Monitor
Error Code
Displayed Message
Actions
restore the retransfer film.
0103A100
Mark on Retransfer Film could not be
detected. Please set Retransfer Film
correctly.
Install the retransfer film correctly. After
installing, close the printer door, followed by
pressing the RESET and ENTER buttons in
sequence to initialize the printer.
0103B000
Ink Ribbon is broken.
Refer to “Mending broken ink ribbon and
retransfer film” in the “XID 8300 Instruction
Manual” (separate booklet) on procedures to
restore the ink ribbon.
0103B100
Ink Ribbon cannot be controlled.
Please set Ink Ribbon correctly.
Install the ink ribbon correctly. After
installing, close the printer door, followed by
pressing the RESET and ENTER buttons in
sequence to initialize the printer.
0103BB00
Card Jam happens in External IC unit.
Please remove the card in External IC
unit.
Press the RESET and ENTER buttons in
sequence to initialize the printer. If the card
is not ejected, turn off the power and remove
the card.
01044400
0104D800
0104FA00
Hardware failure happens in the
printer unit. Please turn off and on the
printer power to initialize the printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104A900
MG encoder is not set correctly.
Please turn off the printer power and
set MG unit correctly.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104AB00
Mechanical failure happens in the MG
encoder. Please turn off and on the
printer power to initialize the printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104AC00
Hardware failure happens in the MG
encoder. Please turn off and on the
printer power to initialize the printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104AF00
Communication error happens
between printer and MG encoder.
Please turn off and on the printer
power to initialize the printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104B900
External IC unit is not set correctly.
Please turn off the printer power and
set External IC unit correctly.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104BA00
Dip switch setting in the external IC
unit is not correct. Please turn off the
printer power and correct Dip switch
setting in External IC unit.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104BE00
Communication error happens
between printer and External IC unit.
Please turn off the printer power and
connect communication cable
correctly.
Turn off the power of the printer. Unplug
the cable connecting the external IC unit to
the printer, and plug in again.
0104BF00
Communication error happens
between printer and laminator. Please
turn off the printer power and connect
communication cable correctly.
Turn off the power of the printer. Unplug the
cable connecting the laminator to the printer,
and plug in again.
Call for servicing if this problem recurs.
0104C000
Hardware failure happens in the
turnover unit. Please turn off and on
the printer power to initialize the
printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104C100
Hardware failure of Heater Cam
happens. Please turn off and on the
printer power to initialize the printer.
Turn off the power of the printer and turn on
again. Call for servicing if this problem
recurs.
0104F000
The temperature of Retransfer
Roller is too hot. Please turn off the
Turn off the power of the printer. Turn on
again after the temperature of the retransfer