Instruction manual

Instruction Manual Page 22
EDIsecure
®
XID 8300 Ethernet Status Monitor
9.2 Network Settings
Caution
1. Determine the “Network Setting” items according to the instructions of the network administrator for
the location where the printer unit is installed.
2. Other network devices may be affected if the “Network Setting” is incorrect.
3. When only USB connection is used, there is no need to specify the “Network Setting”.
4. To apply the “Network Setting” to the printer unit without connecting via USB, do so using the
operation panel on the printer.
 Network Setting: For specifying items related to the network (Ethernet). When the printer is connected
via the network, the set values are shown but setting is disabled.
 When “Obtain and IP Address Automatically” is selected, the IP address, subnet mask, and
default gateway values are automatically acquired from the DHCP server. If the DHCP server
is not found, settings in the “Use the following IP Address” will apply.
Note
1. The IP address, subnet mask, and default gateway values that are automatically acquired from the
DHCP server are not shown.
2. The IP address, subnet mask, and default gateway values may change regularly according to the
DHCP server settings. To use a static IP address such as for the printer driver’s application software,
it is recommended that you select “Use the following IP Address”.
 When “Use the following IP Address” is selected, specify the “IP Address”, “Subnet Mask”, and
“Default Gateway” fields accordingly.
 Use “Session Timeout” to specify the timer interval before disconnecting when communication is not
established after print connection. The default setting is “None”.
 The printer’s MAC address is shown in the “MAC Address” field.
9.3 Security Settings
Caution
1. Determine the “Security Setting” items according to the instructions of the network administrator for
the location where the printer unit is installed.
2. Encrypted communication cannot be established if the “Security Setting” is incorrect.
3. When only USB connection is used, there is no need to specify the “Security Settings”. Encrypted
communication is not possible with USB connection.
4. It is not possible to apply the “Security Setting” to the printer without connecting via USB.
5. Refer to the “Installation Manual” for procedures to create the download file to be used for the
“Security Setting”. Manage the download file according to the instructions of the network
administrator.
 Security Setting: For specifying items related to IPSec of the network (Ethernet). When the printer is
connected via the network, the set values are shown but setting is disabled.
 When “IP Sec Disable” is selected, only communication that does not make use of IP Sec is
enabled. The default setting is “IP Sec Disable”.
 When “IP Sec Enable” is selected, communication that makes use of IP Sec is enabled. Upon
completing the setting using the “Details” button, the “Pre-shared Key” or “Printer Certificate”
selection is enabled.