Instruction manual

Instruction Manual Page 16
EDIsecure
®
XID 8300 Ethernet Status Monitor
Setting a value toward the top right end increases the bend remedy force, however impact of heat on the card
will also be greater. Parts for which the bend remedy force is similar is indicated using the same color in the
setting area.
To disable bend remedy, select the “Disable” radio button. The default setting is “Disable”.
Caution
1. The setting areas serve only as a rough indicator. The optimal value varies according to the card type
as well as the environment in which the printer is used. As such, set the values after trying out under
the environment where it is to be used.
2. Bend remedy is effective when printing on only one side. Performing double-sided printing with a high
bend remedy temperature may cause the card to deform significantly. As such, select the “Disable”
button during double-sided printing.
3. When the “Disable” radio button is turned on, the printer switches to and remains in the preheating
mode (for approximately 10 minutes) until the bendy remedy roller’s temperature has gone down. This
is not a malfunction. Wait for the printer to switch to the Ready mode.
4. When bend remedy is disabled using the “Disable” button, the speed is automatically set to the
maximum value (+2).
5. If the bend remedy force becomes strong, the surface of remedy side will become lusterless.
6 Checking Media Status
6.1 [Media Setting] Tab Sheet
The “Media Setting” screen enables you to display the ink ribbon’s status and specify the card or retransfer
film settings.