Instruction manual

Instruction Manual Page 14
EDIsecure
®
XID 8300 Ethernet Status Monitor
Setting a value toward the top right end increases the transfer force; however heat deformation of the card will
also be greater. The colors below serve as a rough indicator for selection.
Color
Description
 Green
Standard value. Optimal value for the selected card. Select this under normal
circumstances.
 Light Blue
Appropriate range. Recommended range when selecting a value other than the
standard value.
 Yellow
Card bends increases.
 Blue
Retransfer defect may occur.
 Red
Do not choose these values.
Caution
1. The setting areas serve only as a rough indicator. The optimal value varies according to the card type
as well as the environment in which the printer is used. As such, set the values after trying out under
the environment where it is to be used.
It may take a while for printing to start when the retransfer temperature is changed.
2. There is only one standard retransfer temperature. Altering the retransfer temperature on one side
changes the temperature on the other side as well.
3. The range of optimal values varies according to the “Card Type”. You can change the card type in the
“Media Setting” screen.
4. If the card type varies across printers, set the card type to use accordingly. The color of the setting
area varies according to the card type in use.